Teacher
•
7 Messages
remote code denon 1612
Johnie, or anyone. I'm new to this community and would like to have a AT&T remote control the volume on my Denon 1612.
I have a S10-S3 I have used all the codes on the remote codes card provided by AT&T. I can turn off and on my AVR 1612 using 5 of Denon
codes on the card. However I can't control the volume. My old providers Dish and Cox had the code to make their remotes work the volume on my Denon 1612. It's been 2 weeks I'm using 2 remotes you know that blows to have to have 2 remotes to control the sound.
I used every code on remote control program card and I can only turn the Denon off and on. I want to control the volume. I appreciate anyone that can figure this out. Is the silver remote different?
cpd5215
Mentor
•
72 Messages
10 years ago
I am having the exact same issue. I have tried all the codes for my Denon AVR 591, and all of them allow to turn the power on and off to the AVR but none of them allow my to control the volume on the AVR, it just controls the vol on the TV. WHat code did you use? Suggestions. Thanks.
0
0
aviewer
Expert
•
10.1K Messages
10 years ago
att/ok (simultaneously) - 955 - enter (bottom right)
Then the volume will follow the mode button. See if it controls the Denon.
If it does not or you do not want to change modes to change volume, you can set the U-verse STB volume to 15. Then set the TV and Denon volume to comfortable levels. You can then watch U-verse TV in the att mode & vary the volume using either the TV or the Denon to provide audio.
If you ALWAYS use the Denon & you have a code that controls volume you can insert aux between 955 & enter toALWAYS control the Denon.
0
0
cpd5215
Mentor
•
72 Messages
10 years ago
0
0