Contributor
•
3 Messages
Enable wireless gateway
When I had U-verse install I did not have any devices that used the wireless router so the installer disabled it.
Now my wife has an ipad and I need to enable the wireless function on the gateway. Now when I roll over the AT&T icon in the lower right of my screen it states "wireless disabled". How do I activate the wireless function on a 3800-HGV-B?
Accepted Solution
Official Solution
texasguy37
Expert
•
14.5K Messages
13 years ago
Enable the Wireless Interface by accessing the Gateway using the link below. You can also configure the wireless network on this page.
http://192.168.1.254/xslt?PAGE=C_2_1
0
0
Accepted Solution
Official Solution
texasguy37
Expert
•
14.5K Messages
13 years ago
The WPS PIN is not needed.
Wireless is enabled on your RG, you need to enable wireless on the iPad: http://www.ehow.com/how_7383544_enable-wi_fi-ipad.html.
If Wireless Secuirty is enabled on the RG, the Wireless Network Key is shown on the label on the side of the RG.
0
0
Official Solution
denny_fla
Contributor
•
3 Messages
13 years ago
That did it!!!!!!!!
0
0
denny_fla
Contributor
•
3 Messages
13 years ago
Thanks for the help.
When I go to that page it shows the wireless interface is "enabled", but the "WPS PIN" field is blank.
What is the WPS and BTW the icon in the lower right of the screen still show "wireless disabled".
0
0