Mentor
•
69 Messages
Harmoney One and uverse interactive
Anyone have a Harmoney one remote that can help me set up a back button for using uverse interactive? I cant figure it out and getting tired of going through all the menus over and over.
Thanks.
Accepted Solution
Official Solution
oobleck
Scholar
•
389 Messages
13 years ago
This works for a Harmony 550, so it will probably work for other Harmony remotes. Start up the Harmony software, and under the Watch TV function select "Customize Buttons". Then pick a button (I used the DownArrow), select the PVR device for it, and assign the command Back.
--
oobleck
0
0
aviewer
Expert
•
10.1K Messages
13 years ago
Here is instructions for 700 - should be similar -
open harmony software
learn is under both activity and device (PVR device is STB)
click learn on button selected aim U-verse remote & harmony together - follow instructions
once you have function captured you can apply to activty or device - the one you did not just do.
I believe there is flexibility to have a button do different functions under device and activity, but I like to keep them the same for consistency - activity just specifies which device is under control for that activity
I have skip forward and back on an unlabled big up/down button in upper center, in addition to labled buttons at bottom.
0
0
kwinston
Scholar
•
90 Messages
13 years ago
Listen to the poster in post 3, that is what I did. It is easy to customize buttons and add a "back" command, no reason to learn the command like #2 posted.
0
0
Jessme_1
Mentor
•
69 Messages
13 years ago
Thanks everyong. I got it.
0
0
kwinston
Scholar
•
90 Messages
13 years ago
Have fun!!! Once you start customizing buttons, you will then be adding quite a few must have's.
0
0