Contributor
•
3 Messages
Wireless Setup for Smart TV
i just can't figure out how to connect internet to my smart t.v. i have entered everything that the t.v. tells me to do and all i get is 'can't find internet'. please help and make it simple. i'm not that tech. smart. thanks for any help.
Accepted Solution
Official Solution
julywashere
Guru
•
349 Messages
10 years ago
You have two options you can try, WPS and Passcode. If one succeeds, you don't have to do the other.
FOR WPS Set-up
You'll have to enable WPS on your RG.
Continue by configuring your TV's Wireless connection.
There are some secuirty concerns with leaving WPS tuned on. It's recommended you turn it off after you have paired your TV by following steps 1-4 under enabling WPS, except choosing Off on step 4.
FOR NETWORK KEY SET-UP
You will need to know your SSID and your Network key. You can find these printed on the side of your RG or on the Residential Gateway Portal.
0
julywashere
Guru
•
349 Messages
10 years ago
What is your TV model number?
0
0
carmen206
Contributor
•
3 Messages
10 years ago
my t.v. is a phillips 3000 serials led-lcd 46 inch smat t.v. #46PFL 3608/F7. i have tried all different ways of tryin to connect but it just won't. thanks for any help i can get.
0
0
carmen206
Contributor
•
3 Messages
10 years ago
0
0
rebecca36
Contributor
•
2 Messages
8 years ago
good morning, i'm also having the same exact problem with setting up my wireless internet to the phillip's smart tv. i have gotten to the easy setup then after it goes through it say that it can't connect that home is not active.. don't know what to do. please help me:
0
0
rebecca36
Contributor
•
2 Messages
8 years ago
where do i find my passcode??? with setting up wireless internet to phillips smart tv
0
0
deede1
Tutor
•
4 Messages
6 years ago
I followed all the instructions for setting up my tv using the ssid type connection, however after it stopped scanning it stated that connection failed. When I tried to use the 'scan' method the tv displayed 'no connection (wifi) found' I made numerous attempts. What might I be doing incorrectly?
0
0
Morg20
Contributor
•
3 Messages
6 years ago
My Phillips smart tv will not connect to my AT&T hotspot but all my other devices do? Can you help
0
0
slickskipper
Contributor
•
1 Message
6 years ago
I have a Samsung smart tv. When I try to get on the internet I get an error message. Looking for a solution it said I am connected to my local network but unable to connect to the internet. It tells me to check the DNS settings on my IP Settings. It shows the DNS Server as 0.0.0.0. from what I found on Youtube it tells me to manually change the DNS to 8.8.8.8. I have tried that with no success. What should I do?
0
0
myra.ackland
Contributor
•
1 Message
6 years ago
Att told me I would have everything to use my wifi to my tv. It's saying router not detected
0
0