New Member
•
1 Message
Use IP Passthrough and Use BGW320 as an AP
Hi, I'm planning to use IP passthrough to an OPNSense router with multiple 2.5 G ports, but the BGW320 is good enough for my wireless devices. If I leave the gateway's WiFi radios on, setup IP passthrough, and turn the firewall off, will the traffic from the wireless devices use my router?
Accepted Solution
Official Solution
JefferMC
ACE - Expert
•
35.5K Messages
10 months ago
No, clients that connect directly to the BGW320 will still be assigned an IP from the Gateway and it will still perform NAT for them; IP Passthrough doesn't change this at all. Such clients would not be able to access resources behind your router.
0