05-23-2014 7:52 PM
So far, I've done six or so HD recordings. Two were only a little glitchy, but watchable. Two were seriously glitchy, but did calm down enough to make sense. Two were totally useless. These were done during prime time when there was 2 hdtvs and 1 sdtv on. Only one recording was done at a time. The good ones were done between 8a and noon.
I am extremely disappointed in how this is working. My dvr is attached to an sdtv. In that same room, there is also a wireless router and a wireless sensor controller. Both of these units are always on, so I'm not sure how they could be causing intermittant problems. The best recordings were done when no tvs were on. My internet speed tested on an ethernet desktop using speedtest, has been fairly consistant at 20m.
I'm on the verge of chucking uverse and going with somethings else if can't get this recording business straightened out.
Solved! Go to Solution.
05-24-2014 1:30 AM
05-24-2014 7:25 AM
The RG is a NGV589, the DVR is an ISB7500. I'm not crazy about the factory reset. I'll lose all my recordings (not the end of the world), but I assume I'll also lose my series?
Where do I find my max sync rate?
Thanks for your help.
05-24-2014 8:28 AM
I failed to mention a coupla more bits of hardware. When the techs rewired everything, they had to put in a switch between the input from the RG and the dvr. That switch also feeds the two other wired tvs ( 1 hd, 1 sd). I also have a roku xs that is under my new hdtv and far away from the dvr.
The other wireless router is not on this line from the RG. There is a second line from the RG that goes to a computer, so I tucked the router between the RG and the computer.
I don't know if any of this makes a difference, but I would like to give you a complete picture of what is happening here.
Thanks again for your advice.
05-24-2014 12:41 PM
05-24-2014 6:03 PM
05-26-2014 12:25 PM
I did as aviewer suggested and separated services from tv and now all is well. Thanks so much. As a test, I did two hd recording last night and they both were fine. Woohoo.
Now, my problem is that I would like to combine my two wireless networks into one. I understand that I give the two routers the same name, turn off dhcp on the secondary router and change the start ip address on the primary to not assign the same address as the secondary router.
Is that correct? is there more?
Having service trouble? There is an app for that! Use our troubleshooting tool or text myATT to 8758 to download the app. It is much faster than posting on our forums. You will also find some helpful articles below.
© 2016 AT&T Intellectual Property.This link will open a new window All rights reserved. AT&T, Globe logo, Mobilizing Your World and DIRECTV are registered trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks are the property of their respective owners.
Congratulations! You earned the Liz badge!