Teacher
•
17 Messages
UVerse box master volume
Is there a way to adust the master volume on the reciever box. After I program my TV remote I can't find a way to adjust the volume on the reciever. If possible I would prefer to set my TV volume and use the master volume control instead of setting the master volume and adjusting the TV volume while watching.
My issue is....I set up a new HDTV a couple weeks ago and when I pause/unpuase I get a 'pop' sound from the speakers. Kinda like if you plugged in a guitar to an amp that had the volume turned up high. It seems like it is causeing a little undue stress and I would like to lessen it. I'm pretty sure that if I turn the master volume down that this will lessen the pops.
However, the only way that I can figure to do this would be to unprogram the TV from the remote, adjust the master volume, and then reprogram the TV on the remote.
There must be an easier way, right?
Accepted Solution
Official Solution
aviewer
Expert
•
10.1K Messages
13 years ago
If you then press enter (bottom right) the volume control will follow the mode key. When the att key is active (normal watching for channel changes) the volume changes in the STB. When the TV key is active the TV volume changes.
0
Accepted Solution
Official Solution
jamileh
Former Community Manager
•
5.2K Messages
11 years ago
Here is a link with information about multipe U-Verse remotes.
Each section contains a programming guide, a troubleshooting guide and a user guide.
http://www.att.com/esupport/article.jsp?sid=KB409004
0
0
rockychai
Teacher
•
17 Messages
13 years ago
Thank you -
That did exactly what I was looking to do- control the volumes according to the mode key selected.
-Cheers
0
aviewer
Expert
•
10.1K Messages
13 years ago
0
0
rockychai
Teacher
•
17 Messages
13 years ago
One more thing.... Let's say I want to return to the default volume settings with the TV volume as the dominant choice. How would I do that?
Also, is there a list of codes online for the remote settings?
0
0
rockychai
Teacher
•
17 Messages
13 years ago
http://www.uverseremote.com/setting-up-your-volume-channel-and-power-options-on-uverse-remote/
0
0
JakeOMite
Contributor
•
1 Message
10 years ago
This was exactly what I needed, thanks!, but I need to "undo" this. My UVerse box volume was set too low when I programmed my remote to work with my TV. Doing the "955" fixed helped me to raise the UVerse box volume to "max" but now I want to switch back to controlling the volume with my TV, not the UVerse box. Can you tell me how to change back to that?
Thanks,
Jake
0
0
aviewer
Expert
•
10.1K Messages
10 years ago
0
0
dwolff51
Contributor
•
1 Message
6 years ago
Not sure if anyone is still following this, but I have a related problem. I have UVerse with A30-RF1 remote. I just installed a new Denon AVR. When I adjust the volume (under the AT&T device button), both the TV and Receiver volumes show as adjusting on the TV. How can make it control ONLY the Receiver (without having to switch to the AUX button)? That's how it worked with my previous Receiver.
0
0