11-19-2013 6:53 AM - last edited on 11-22-2013 9:41 AM by beckyww
Att Uverse Tv was set up in my home recently. The service is great so far, except for one irritating thing. Each day that I turn on one Tv, a message appears stating to hit OK to watch TV. Whenever I do, still unable to flip channel until I press power putton on reciever. That might seem like a simple solution. I don't think I should have to press the power button to watch TV or flip channels. The message do not appear when I turn on the other two television hooked up to Uverse. What can I do to resolve this issue? Thanks in advance.
Solved by: Go to Solution.
11-19-2013 7:45 AM
Your Uverse remote toggles between ATT & TV as indicated by the top row of buttons on your remote.
Make sure the ATT button lights up as you are trying to change the channels or complete other functions on the Uverse box (Forward/RR/Pause).
If the TV button (next to the ATT button) is lighting up, then it's controlling the TV and not the ATT box.
I say this because my DH panics when the channels won't change. He actually called me yesterday because he was at home and I was out. I told him, "Hit the ATT button at the top!". His reply "Oh OK....it's working now...."
How it gets off the ATT button and on to the TV button, I have no idea....but it does.
11-19-2013 7:46 AM
11-19-2013 8:54 AM - edited 11-19-2013 9:26 AM
naturalista - Skeeter and MT give good advice. There is another possibility. When you turn off the STB/TV with the power button. It does not turn off the STB, only the TV & you cannot tell because the TV is off. When you power down be sure you are pointed at the STB and the oval green light goes out on the STB.
Then when you try to turn it on, you will. Instead of turning it off as you may be doing now.
To reinforce previous advice - Be sure you are in att mode on the remote & it is aimed at the STB.
11-20-2013 8:27 AM
11-20-2013 8:52 AM
11-20-2013 1:40 PM
The green light does not go out when I point remote toward STB. I press the att button and now things are normal. Thanks.
So, when you are through watching TV and you press the power button, does the green light still not go out on the STB? it should. If your remote is correctly programmed, it should send out at least two commands. One to power down the TV and another to power down the STB. If you press Power on the remote, you should see both the TV and ATT buttons light up. If they don't, something is not correctly setup. Another factor is the delay. Since it sends two separate commands, both do not happen at the same time. It is the TV off and then STB off (or vice versa, there is an option for order). My wife sometimes sets the remote down too fast and only one command gets there, as the other command is bouncing off the floor, lol.
11-22-2013 8:58 AM
Anytime! Welcome! Don't be a stranger on the forums.
12-22-2013 4:25 AM
Thank you for this answer. This solved so many problems for me. Watching tv has gotten too complicated for some of us older people.Too many buttons to push and too many wires to hook up.
Getting U-verse? Great! Welcome to the family! Check out our articles below regarding your Install, Your Appointment, Bill, and other features!