10-14-2012 11:04 AM
As of this morning the "guide" and "info" buttons on our remote no longer work. They worked fine yesterday. I replaced the batteries. No change. I've attempted to reset to factory setting and reprogramming in our TV (Sanyo) and no change. What else can I try or should I just contact AT&T for a new remote? Thanks!
Gigi in Dallas
Solved by: Go to Solution.
10-14-2012 11:11 AM
10-14-2012 11:31 AM
Call TS using the phone number in my sig and request a new remote control. They are free, so if the CSR tells you there is a charge for the remote politely end the call. Then call back and speak to another CSR.
10-14-2012 11:45 AM
Thanks aviewer for your response. Holding down the "guide" button and the AT&T button at the same time corrected the problem. Have a great Sunday!
10-15-2012 7:24 AM
Once you press the AT&T Button, you should not have to press it again to use guide and info. (Or hold them down at the same time at all). Chances are someone accidently pressed the TV, AUX or one of the other buttons near the AT&T button, which tells the remote to go into a mode to control that device only. Once you press AT&T, you are telling the remote to work with the AT&T Set Top Box again. So you shouldn't need to hit AT&T again unless someone accidently pushed the wrong button again.
12-06-2015 3:35 PM
I cannot get the ATT button on the remote to work at all so Guide and Menu want work and there is no sound coming from my wireless receiver. A technician came and told me what I already knew but did not replace the receiver or remotes. He replace the modem and took off with my back up battery pack. What do you make of that?
Getting U-verse? Great! Welcome to the family! Check out our articles below regarding your Install, Your Appointment, Bill, and other features!