Tutor
•
4 Messages
Programing Uverse remote
Just got a Samsung 7100 smart tv. Went through remote setup for uverse remote. I can turn uverse off/on, access guide and volume, but cannot get the tv to turn on/off with uverse remote. After following the instructions, it works once until the tv is turned back on and I have to hit the att button to access guide then it won't work again. What am I doing wrong?
Accepted Solution
Official Solution
aviewer
Expert
•
10.1K Messages
9 years ago
If you still have the old s10 remote, When the TV is programmed it is added to the power toggle sequence when in the att mode.
You want to do everything in the att mode.
When you press the power button watch the att & TV buttons light up. in sequence.
As a test, press the tV button then power toggle. Does it turn only the TV off/on?
If yes you have the right code. If no keep looking for the right code.
If you have an S20 remote, read the directions for power - http://www.att.com/media/att/2014/support/pdf/S-20_U-verse_remote_user_guide.pdf
0
0
Bagder
Contributor
•
1 Message
7 years ago
0
0