02-05-2011 3:14 PM
Here's a guide on how to Program the AT&T Universal Remote Control to your TV.
Click Here for the Link. It also includes the codes for different brands of TV. If the guide help you please put a FeedBack or Rate me on the guide website.
Previous Sup - AT&T Uverse
Solved by: Go to Solution.
02-26-2011 6:16 AM
Samsung lists about 20 factory codes. How can you tell which one matches the TV you have?
03-04-2011 7:23 PM
I cannot find any codes for my TV - it is a Dynex. My U-Verse remote will run the channels, but not the power or the volume. What next?
03-19-2011 3:02 PM
I have a Samsung TV and a seperate Samsung Sound bar. How do I program the U-verse remote to turn the TV on and off, but the volume is the sound bar. Don;t see a code for sound bar that I guess I would program under Aux.
08-28-2012 4:19 PM
I have programmed the u-verse to turn my Sony receiver on and off, only one of the codes work. However, it will not adjust the sound through the receiver, it adjusts the volume on the tv. I seem to remember having to do something with the cable remote previously. Please help!
08-28-2012 6:17 PM
- edited 08-29-2012 9:38 AM
dyoung78 - Rereading your post I think your request was for an HT like amplifier/receiver. not the STB. Been reading too many posts where people call the STB a receiver.
But the answer is the same - If you press the aux button the volume control will always be the Sony. No mode button & you need to press the aux button while watching to control the Sony.
How about turning everything on at once? Code - 977.
Press att/ok- 977- att- tv-dvd-aux -enter Then one power push turns everything on.
- edited 12-07-2015 10:38 AM by davidbk
Here is an article that discusses programming your remote control: http://www.att.com/esupport/article.html#!/u-verse-tv/KM1009898
If still having problems, check out this post here.
03-21-2013 6:39 AM
I tried every single one and none of them worked. We have just come to accept that we have to use two remotes - bummer.
03-21-2013 6:48 AM