Getting a "gear" symbol and red x on screen when trying to pair new receiver to WAP.
New receiver and WAP won't pair. Pushed WAP button - then Receiver "OK" button. Afterwards will get a Gear symbol on screen for extended period. Eventually it will change to red X. (No error number shown). LINK green light and red REC light begin to blink simultaneous. No bars shown. Tried at least 10 times to pair, no luck. This is a new receiver (received yesterday) replacing an older Cisco wireless receiver that failed. Other TV in house with Uverse wireless receiver is working perfectly from WAP and Gateway. Tried resetting WAP, same result. Tried Resetting Res. Gateway, same result. Held power button on Receiver for 10 seconds to reset, no change. Unplugged and re powered Receiver same result. TV perfectly works on Internet streaming through other HDMI port. TV will also work perfectly on ATT Uverse with a swap of the other wireless receiver.
Re: Getting a "gear" symbol and red x on screen when trying to pair new receiver to WAP.
In all the stuff you rebooted you didn't mention whether you rebooted the dvr? Did you?
Try the troubleshooting steps described here. If you get to the disaster recovery step and that still doesn't fix the problem I assume something is really wrong with that receiver and you will need yet another replacement.
This is a public forum and I am a customer just like you. Click kudo if you feel this post is helpful and "Accept as Solution" if it solves your problem.
Award for Community Excellence 2019 Achiever* *The views and opinions expressed on this forum are purely my own. Any product claim, statistic, quote, or other representation about a product or service should be verified with the manufacturer, provider, or party.