Explore & discover

Helpful Links

Getting a "gear" symbol and red x on screen when trying to pair new receiver to WAP.

Highlighted
Contributor

Getting a "gear" symbol and red x on screen when trying to pair new receiver to WAP.

New receiver and WAP won't pair.  Pushed WAP button - then Receiver "OK" button.  Afterwards will get a Gear symbol on screen for extended period.  Eventually it will change to red X.  (No error number shown).   LINK green light and red REC light begin to blink simultaneous.  No bars shown.  Tried at least 10 times to pair, no luck.  This is a new receiver (received yesterday) replacing an older Cisco wireless receiver that failed.  Other TV in house with Uverse wireless receiver is working perfectly from WAP and Gateway.   Tried resetting WAP, same result.  Tried Resetting Res. Gateway, same result.  Held power button on Receiver for 10 seconds to reset,  no change.  Unplugged and re powered Receiver same result.  TV perfectly works on Internet streaming through other HDMI port.  TV will also work perfectly on ATT Uverse with a swap of the other wireless receiver.

Need solution.

1,887 Views
Message 1 of 4
ACE - Expert

Re: Getting a "gear" symbol and red x on screen when trying to pair new receiver to WAP.

In all the stuff you rebooted you didn't mention whether you rebooted the dvr?  Did you?

 

Try the troubleshooting steps described here.  If you get to the disaster recovery step and that still doesn't fix the problem I assume something is really wrong with that receiver and you will need yet another replacement.

___________________________________________________

This is a public forum and I am a customer just like you. If you find this post helpful in solving your problem then feel free to kudo it. If it is also the solution then consider clicking "Accept as Solution".
Award for Community Excellence 2019 Achiever*
*The views and opinions expressed on this forum are purely my own. Any product claim, statistic, quote, or other representation about a product or service should be verified with the manufacturer, provider, or party.
Message 2 of 4
Employee
Solution
Accepted by ACE - Expert (ACE - Expert)
Accepted by JefferMC
‎01-08-2019 1:57 PM

Re: Getting a "gear" symbol and red x on screen when trying to pair new receiver to WAP.

Which wireless receiver model?

Which WAP model?

 

If received a 2nd gen WIFI receiver such as 7105 or 2500 requires a 2nd gen WAP of either VEN501 or 2500.

 

If have a 1st gen WAP VEN401 and 2nd gen WIFI receiver will not pair.

 

Will need to request a 2nd gen WAP either be shipped or schedule a tech appointment.

*I am an AT&T employee, and the postings on this site are my own and don't necessarily represent AT&T's position, strategies or opinions.
Tags (1)
Message 3 of 4
Contributor

Re: Getting a "gear" symbol and red x on screen when trying to pair new receiver to WAP.

Thank You, Thank you That is the solution to my Problem. Based on your info, I looked and found I have a 1st Gen. WAP of VEN401-AT and the new receiver is a 2nd Gen., VIP 2500.

I had called Uverse Support again yesterday, and have a Tech appointment in two days. So hopefully with your info he'll be able to swap out the old WAP. Thanks again.

Message 4 of 4
Share this topic
Share this topic
Workarounds for resolving common errors. View U-verse Error Code Help!
Additional Support