Contributor
•
3 Messages
hooking up an emitter to uverse dvr
Where should the emitter be hooked up to the Uverse DVR
Contributor
•
3 Messages
Where should the emitter be hooked up to the Uverse DVR
Accepted Solution
Official Solution
ATTHelpForums
Community Support
•
2.7K Messages
7 years ago
Hi @k.lohman10,
I believe you are talking about an IR Emitter. If that is the case, on most receivers, it is to the right of the red record light. To test, you can put a piece of tape or something to block that area and see if your remote works. If it does not, that's where the IR sensor is. Hope this helps.
David, AT&T Community Specialist
0
Accepted Solution
Official Solution
JefferMC
ACE - Expert
•
35K Messages
7 years ago
A single thickness of tape will often not block IR signals into the IR receiver of the set top. In some cases, it actually only dampens it enough to improve accuracy of reception from a "too hot" remote control IR emitter.
0