ACE - Professor
•
5.8K Messages
Wireless receiver access point
We currently have 12 mb internet and u200 TV service.There is an INID on the outside of the house and an I38hg access point in the house. If I get a wireless receiver, do I need another access point or can the wireless receiver connect to the I38hg? My plan is to connect it via an ethernet cable but want to know how it connects wirelessly.
Award for Community Excellence Achiever*
*I am not an AT&T employee, and the views and opinions expressed on this forum are purely my own. Any product claim, statistic, quote, or other representation about a product or service should be verified with the manufacturer, provider, or party.
*I am not an AT&T employee, and the views and opinions expressed on this forum are purely my own. Any product claim, statistic, quote, or other representation about a product or service should be verified with the manufacturer, provider, or party.
Accepted Solution
Official Solution
ATTU-verseCare
Community Support
•
6.7K Messages
10 years ago
Hi @browndk26,
The wireless receiver actually uses a different WAP than a i38hg. It will plug into the Ethernet port in your i38hg and sync with the Wireless Receiver. You can also connect the Wireless receiver via Ethernet cable for a hard wired connection, and you will not need the wireless access point connected if it is connected hard wired.
Hope this helps.
-David T
0
0
Accepted Solution
Official Solution
JefferMC
ACE - Expert
•
35.1K Messages
10 years ago
As long as none of the devices you connect to the same switch as your receiver is a wireless access point/router, you should be able to leave them connected to the switch full time. Nothing you listed would pose a problem.
0
0
aviewer
Expert
•
10.1K Messages
10 years ago
Wireless receivers connect differently than wireless internet. A WAP connects up to two wireless receivers. The WAP would connect the same as a wired receiver. The only way to improve range of a WAP is a longer connecting wire to place it better.
The I38hg transmits for the internet wi-fi, You can have multiples of these to improve internet wireless.
0
0
browndk26
ACE - Professor
•
5.8K Messages
10 years ago
0
0
aviewer
Expert
•
10.1K Messages
10 years ago
Yes, the WAP is included in the wireless receiver package. That may be why thet have the one time $49 charge.
0
0
Darknessrise
Professor
•
2.4K Messages
10 years ago
While you would still need a WAP, you can connect your wireless devices capable of 5 GHz networking to the WAP given to you with the wireless receiver. This is not supported by AT&T.
0
0
browndk26
ACE - Professor
•
5.8K Messages
10 years ago
Thanks for the responses everyone.
0
0
browndk26
ACE - Professor
•
5.8K Messages
10 years ago
Ordered the wireless receiver today. Due Monday but maybe it will arrive earlier. Any tips on how to install it?
0
0
ATTU-verseCare
Community Support
•
6.7K Messages
10 years ago
I would install it following the instructions to do it wireless. Once you get the wireless aspect of it working, you can just connect the Ethernet cable to it and connect it hardwire as you planned. After that, you can unplug the WAP that came with the Wireless receiver.
-David T
0
0
browndk26
ACE - Professor
•
5.8K Messages
10 years ago
Davidt,
The wireless receiver will be in the basement about 50 feet away and one level below the I38hg. Should I plug the WAP into the ethernet cable I will be using for the wireless receiver and keep the WAP close to the receiver when I activate it? Or just keep it near the I38hg?
0
0