Tutor
•
4 Messages
Wired receiver requires technician install? Does wireless receiver let you use Ethernet port?
I attempted to order an additional U-Verse receiver for my existing 2-receiver (VIP1225, VIP1200) setup. It would only allow me to add a wireless receiver. A chat revealed that a wired receiver requires a technician visit.. ?!!
1. Is this a steadfast rule? Having done the CAT-6 in my house and configured additional wireless routers to work with the RG, I figure I'm capable enough to plug in an additional receiver into the RG.
2. If not, does the wireless receiver also function as a wired receiver?
Accepted Solution
Official Solution
texasguy37
Expert
•
14.5K Messages
12 years ago
The wireless receiver can also operate as a wired receiver with an Ethernet connection. The wireless receiver will give you much more flexibility than the wired receiver.
0
dougbee
Tutor
•
4 Messages
12 years ago
0
0
texasguy37
Expert
•
14.5K Messages
12 years ago
You need to call Customer Service to order. They are delivered by UPS. You cannot pick them up at an AT&T store.
0
0
bri_man_65
Scholar
•
373 Messages
12 years ago
They were charging $49 for the wireless receiver (possibly for the Wireless Access Point that comes with it). As far as I know that charge still exists.
0
0
RCSMG
Expert
•
23.3K Messages
12 years ago
That may be the case, but if a tech has one on his truck he can offer to give you one at no charge. The prem tech who gave me a 2250 offered me a wireless stb but I told him I didn't want one. If it is being shipped, then unless you get a very cooperative CSR, avoiding the fee would be impossible. IMHO
0
0
rebirth24
Contributor
•
3 Messages
11 years ago
"The wireless receiver can also operate as a wired receiver with an Ethernet connection. The wireless receiver will give you much more flexibility than the wired receiver."
So are you saying I can utilize the COAX connection on the wireless receiver for INPUT from the gateway situated elsewhere and then use the HDMI out to the TV and the Ethernet for network connectivity??
0
0
texasguy37
Expert
•
14.5K Messages
11 years ago
No, the wireless receivers only accept a cat5 (i.e. Ethernet) connection for the input. A coaxial cable cannot be used for the input.
0
0