11-08-2011 9:15 PM
I am attemtping to connect a Sony Blu-Ray/DVD Home Theater System BVD-E780W with my Uverse Motorolla VIP1225 receiver. I have TV mounted above fireplace with HDMI going through the wall and into a cabinet. Another HDMI wire cannot be fished through the wall without the removal of built-in bookcase.
So I have attempted to use a Rocketfish splitter. The HDMI coming out of the TV, runs into the splitter. An adidtional HDMI goes from splitter to Uverse box and another to Blu-ray player. Method does not work. In fact, even when just using the splitter to connect TV to UVerse my connection is lost.
The Blu-Ray player has one HDMI out outlet and two HDMI inputs. I attempted to route HDMI from TV into Blu-Ray and then out to UVserse but this did not give me a signal either. Does anyone have experince hooking up this type of Blu-Ray player with the motorolla uverse box?
Any help is appreciated.
Solved by: Go to Solution.
11-09-2011 5:09 AM
11-09-2011 6:06 AM
I think you need a two port switch instead of a splitter. Go to Amazon and pick one up. Then hookup the outputs from the blueray and stb to the HDMI input on the tv. When you use the blueray you will have to turn the stb off.
11-09-2011 7:14 AM
According to the manual, you should be able to run a Set Top Box through your home theater system using HDMI. Here is a link to the support site:
Make sure the HDMI cables are plugged into the correct inputs.
It shows you have to cycle through the inputs using the FUNCTION button on the remote.
11-09-2011 7:38 AM
Visit these related resourcesView U-verse Troubleshooting!