Red X and 8 underneath

If you are having issues with:

• Receiver resets
• Loss of recordings
• Pixilation
• Freezing
• Or any of these error messages above, check out our steps below to resolve your U-verse TV service:

Rebooting the receiver is the quickest way to resolve most service issues:

• Press and hold the power button(located on the left side of the receiver) for 10 seconds.
• Another way this can be done is unplug the power cord from the wall outlet, then plug it back in after 10 seconds.

We recommend plugging our devices directly into the wall. If you must use a power strip, use the surge protectors that are designed for high powered electronics. Not doing this may result in:

• Receiver resets
• Loss of recordings
• Pixilation
• Freezing

Make sure all connections (wall to receiver, receiver to TV) are placed firmly into the device. If the cables going from the wall to the equipment are damaged, feel free to contact us here.

To avoid loosing your saved programs, perform the Non-Disaster Recovery for DVR/Receivers:

1. Unplug the receiver or DVR power cord from the wall or back of the box.
2. Wait 10 seconds.
3. Plug in the receiver and DVR.
4. When three white dots appear on the screen, unplug the receiver/DVR again.
5. Repeat this process two more times.
6. Plug the receiver/DVR back in on the third time and leave in. Three white dots appear followed by a gear with a status bar at the bottom of the screen. If the Recovery screen does not appear, repeat the steps above.

If you are still experiencing issues with you DVR after that, perform a Disaster Recovery on the device.

Disaster Recovery for DVR/Receivers:
WARNING!: Disaster Recovery steps will cause your DVR to lose all pre-existing data such as: Recordings, Parental control settings, Aspect ratio settings

1. Using the above image as guidance, hold down the Down arrow key + OK key +Power key outlined in red at the same time to power down the DVR.
2. Continue pressing these keys until a gear appears on the screen and release the Down arrow + OK keys.
3. If the gear on the TV screen appears, wait until completion.
4. If the gear on the TV screen does not appear, repeat the disaster recovery process.

If the previous steps have been exhausted and the TV receiver continues to malfunction, please send a private message with your account number and contact details to ATTU-verseCare for further assistance. If you are not a member of the U-verse community forums, we welcome you to register and reach out to us.

-ATTU-verseCare