09-06-2018 12:20 PM
I have two Cisco ISB7005 wireless receivers and a VEN501 wireless access point. I want to use one receiver wired using its ethernet port and keep the other one wireless. How do I do that? Thanks.
Solved by: Go to Solution.
09-06-2018 1:06 PM
Just connect the receiver's network port to one of the yellow ethernet ports on the back of the gateway with an ethernet cable.
Reboot both the gateway (pull plug for 15 secs. and let it fully reboot). Maybe the WAP too but most likely not.
09-06-2018 5:46 PM
Unplug the WAP power source....
Wire the 7005 ethernet.
Reboot both gateway and reciever.
The receiver will look for the WAP first, time out and then connect on the ethernet.
Note... may have to depress enter button a few times for errors on screen, will take maybe 10 minutes total.
Once the reciever is functioning properly, then power up the WAP for the other wireless receiver to function.
|09-05-2014 3:50 PM|
|09-12-2012 10:19 PM|
|10-21-2014 4:20 PM|
|07-23-2016 7:29 PM|
|03-24-2018 9:52 AM|