12-17-2018 5:47 PM
I have 2 U-Verse wireless receivers that get a poor signal resulting in bad reception, and unfortunately, moving the WPS receiver is not an option. Since the wireless receivers do have an Ethernet port, can I just plug them directly into the wall jack or network switch to utilize a wired connection? I have a 3rd wired U-Verse receiver that works well (presumably because it is hardwired). If I do plug the wireless receivers to the wall jack, is there any provisioning AT&T needs to do? Is that even possible or do I need a different receiver altogether? I did notice the wireless receivers are a different model than the wired.
Solved by: Go to Solution.
- edited 12-17-2018 9:39 PM
The way you convert a wireless receiver to wired is ethernet connect it from one of the free yellow ethernet ports on the gateway to the network port on the wireless receiver. Remove the WAP (if there is only one wireless receiver) and reboot the gateway to updates its device list. Otherwise leave the WAP connected but still reboot the gateway.
Bottom line, no, there is "wall jacks" you can use unless your house is ethernet wired through those wall jacks (must be ethernet sockets) through some centralized patch panel where you can effect the proper inter-connections from gateway to receiver.
12-18-2018 4:19 AM
My house is wired for Ethernet in every room and it all runs back to the AT&T patch panel. FWIW, my entire neighborhood was pre-wired for AT&T because they're the only current provider. If I understand you correctly, I should just be able to plug in the network cable and turn off the WAP (which sits next to the RG). Am I able to utilize a network switch? Ethernet wall port -> Network switch then Port two on the switch -> U-Verse receiver.
12-18-2018 8:18 AM
If you mean a unmanaged gigabit ethernet switch (e.g., Netgear GS105NA) then yes I believe you can so long as you don't also connect your internet devices through that same switch. The IPTV multicast traffic and internet traffic don't play nice with one another (tv stuff won't work). That's not to say it can't be done but then you need managed switches. For that here are two related threads,
Visit these related resourcesView U-verse Troubleshooting!