Contributor
•
2 Messages
Uverse Error Code: 0 - Failed to load resource
Receiving error code when I use the channel down key. I've pressed the "back" key, error message clears. Appears again when channel down key is used. I've rebooted three times, changed batteries, but problem continues.
Accepted Solution
Official Solution
ATTHelp
Community Support
•
230.7K Messages
5 years ago
Hi @dm6072,
We are aware of error code 0. You can power cycle your receiver by pressing the power button for 10 seconds or by unplugging and re-plugging the power cord to correct the error.
Dee, AT&T Community Specialist
0
0
Accepted Solution
Official Solution
ATTHelp
Community Support
•
230.7K Messages
5 years ago
Hi @dm6072
We're currently working on a solution to the error code 0. In the meantime, try this method: unplug the receiver from the wall, wait 10 seconds, plug it back in and wait for 3 white dots to appear on the screen, and unplug the receiver again. Do this two more times. The third time, leave the receiver plugged in and it will reload.
Aminah, AT&T Community Specialist
0
0
dm6072
Contributor
•
2 Messages
5 years ago
0
0
cet201hs
Contributor
•
1 Message
5 years ago
error code 0 - failed to load resource kx:failed to load resource WebException: The remote name could not be resolved SocketException: A socket operation encountered a dead network
0
0