07-05-2012 7:28 AM
My 2WIRE modem/router was installed at one end of my house. The wifi signal does not make it all the way across the house. I'd have to pay AT&T to move the router which I'd rather not do. I bought the SR300 Smart Repeater from Amped Wireless that worked initially but no longer does. After several conversations with their tech support (which is very good and free!) I've determined that the 2WIRE does not play well with my repeater. The folks at Amped claim that this is an intentional limitation programmed into the 2WIRE by AT&T. When I spoke with AT&T U-verse support they suggested that I could by a repeater but could not give me a list of brands/products that will work with the 2WIRE device. Has anyone else been able to boost their signal off of the 2WIRE router?
07-05-2012 4:18 PM
07-11-2012 9:58 AM
I use a Netgear Repeater and it works fine. I "think" it is a WRT2000. I am not at home at the moment so can't confirm the model, but if you go to the Netgear site, they should show it.
05-15-2013 9:19 PM
I finally got my Linksys router working with the 2WIRE router. Like everyone else, I couldn't get my repeater to work with the 2WIRE router, but it worked with my LinkSys router. I got nowhere with Uverse technical support. However, this is what I did.
I changed the IP address on my Linksys router from 192.168.1.1 to 192.168.2.1. Then set the router for DHCP. Plugged the router into the 2WIRE router (or access point as AT&T likes to call it) and let it get an address from there. Viola. Everything works. Now I can return back to using OpenDNS and have full control over my router.
I also have my repeater working again with the LinkSys router. I'm going to let everything ride for now. In about a week, I plan to turn off the Wifi broadcasting from the 2WIRE router and route all traffic through my trusty LinkSys router.
01-17-2014 12:03 PM