05-03-2013 3:04 PM - edited 05-03-2013 3:08 PM
I have followed the instructions on the guide using the 977 code. I press the AT&T Button 2 flashes. Then the TV button two flasehes the press enter. Three flashes on the TV button. I can turn on and off the TV using the TV button but it does not work with the AT&T button.
I have a Westinghouse LD-4680 with the first Sony code 1002.
I just noticed that the volume works as well with the AT&T button pressed so it is only the power with AT&T button pressed. Any ideas?
05-03-2013 3:37 PM
05-04-2013 11:37 AM
Try menu>help>system setup>program the remote control, then choose your type of remote and continue. Good luck
Please NO SD stretch-o-vision or 480 SD HD Channels
Need Help? 1-800-288-2020, After he gets acct info, press # a bunch of times, get a menu from Mr. Voice recognition
Your Results May Vary, In My Humble Opinion
I Call It Like I See It, Simply a U-verse user, nothing more
09-28-2013 7:25 PM - edited 09-28-2013 7:25 PM
Did you ever get this figured out? I have the exact same issue with my Westinghouse TV.
09-28-2013 7:37 PM
09-29-2013 8:53 AM
aviewer, that didn't work either. The lights on the remote flash like it should be working but it doesn't. I have to turn them on and off sepereately.
09-29-2013 10:00 AM
09-29-2013 4:14 PM
Looking at the end of the remote with the webcam on my laptop when I push the power I see the white lights when it turns the STB on/off, then it lights again for the TV but the TV does nothing. right against the TV IR sensor or bouncing off the back wall does nothing.
Just to clarify this is just when trying to do the TV and STB simotaniously. The remote will turn the TV on/off after pushing the TV button on the remote.
09-29-2013 4:39 PM
09-30-2013 6:19 PM
OK, went and bought some of that tape today. Didn't work. Tried the remote with one of my other TVs and it worked fine. Just some issue with the Westinghouse, guess I'll just have to live with it. Not to much of an issue at least.
09-30-2013 6:33 PM