04-16-2012 7:38 AM
Seeking to replace a Mitsubishi 65" with another 65 or perhaps 70" set. Research has left some unanswered questions. Have seen many comments that plasma sets use more power than LED units. Have not seen mention of how much. Is usage doubled? Up 10%? Another item is THX Optimizer/calibration. Is this an important item or just marketing? Many sets now are 3D or 3D ready. I am not currently interested in 3D, should 3D sets be avoided? Another common feature is WiFi & smart sets. What is the point?
04-16-2012 1:23 PM - edited 04-16-2012 1:25 PM
It will be hard to find a new flat panel of that size that does not have 3D but the beauty part is you don't have to use it and usually the 2D picture quality is better.
Plasma's do use more watts than LCD's.
Plasma's handle quick motion better than LCD's but at least their lag has been dropped to 4ms.
Plasma's can do Blacker than Black better than LCD's (note nothing beats a CRT in that arena currently)
LCD's work better in a brightly lite room or a room with a lot of open windows.
LCD's are harder but not impossible to have image retention.
A lot of info can be had on AVS forums.
A very nice LCD is the new ELITE but set down before you pull up the price.
My personnal preference for bang for the buck would be the new ST50 models from Panasonic in what ever size you want from 42 to 65.
You want either an ethernet or wi-fi connection for firmware upgrade and diagnostics besides the other frills that a smart TV has to offer.
04-16-2012 5:36 PM
I looked at weight as well, and plasmas appear to be heavier than LCDs from what I read. I went with LCD and a matte screen because kitchen window is directly opposite TV wall (plus windows on 4 sides of room!).
When I bought ours (only 55"), plasmas were a couple hundred dollars cheaper, but for our needs, the LCD won out. LEDs were WAY expensive then as they were new to the market.
04-17-2012 1:16 PM
Thanks for the tip on AVS forums. Lots of good information there, in fact, way to much for me. I just want to watch a nice TV without becoming and electrical engineer.
04-17-2012 1:47 PM
I got a tip from an expert on our forums that it isn't necessary to go for the higher MHz frame/refresh rate. I took that advice and went with 60 (over 120 or 240), and have been happy with it.
If you're a sports fan, you might want to go higher.
One thing I would advise, get one with as many HDMI ports on it as (affordably) possible. Everything is headed that way, so it will be easier connections for new equipment.
04-17-2012 3:17 PM
I have discovered that Cnet has a TV buyers guide that addresses most of my questions in an easy to understand manner. I would recommend it to those who need buying help.
04-17-2012 7:51 PM
When you go shopping in places like Target,Walmart and Best Buy just be aware that your home is not going to have a dozen floresent lights in your living room so they run the panels hot on display but at least the Magnolia section in BB is closer to your actual viewing at night.
04-18-2012 7:40 AM
Good point about the lighting Oz. Only problem with BB is they run a super HQ video loop on their TV's where you may not see the same thing short of using a Blu-Ray player at home. Not saying it's a 1080p signal but awfully good/sharp. At least since all the TV's are normally running the same signal you can see the differences between the picture quality on the sets.