Anabanana486's profile

Tutor

 • 

4 Messages

Thursday, July 14th, 2011 10:49 PM

Reset remote/deprogram

I programmed my S10-S1 remote to be able to control my Sony surround sound and it worked, but because it's already set up to control volume on the TV- the remote volume only controls the TV volume not the AUX/surround.

Is there a way to unprogram the tv part or reset the remote and start all over?

Thanks!

Accepted Solution

Official Solution

Expert

 • 

10.1K Messages

13 years ago

anabanana486,

In your OP you say you had the aux key programmed to control the SONY (including volume??) but the volume controlled the TV volume (in att mode??)

The device control for volume is 955. After you have programed your devices -

att/ok key - all mode keys flash twice

955

press device you want to always control volume
or
press enter key and volume is controlled by whichever device is selected while watching.

Expert

 • 

23.3K Messages

13 years ago

If the remote doesn't have some kind of battery backup if you remove the batteries for about a minute should wipe out the current programming.

Tutor

 • 

4 Messages

13 years ago

I left the batteries out for about 5 minutes and no luck 😞

Expert

 • 

23.3K Messages

13 years ago

Thats all I could think to try.

Tutor

 • 

4 Messages

13 years ago

Ok, I reset it using ATT+OK then code 900. Now I gotta find an AUX code that will get the remote to control all of the surround sound features.

Tutor

 • 

4 Messages

13 years ago

Thanks sooo much! Works perfect 🙂 now I don't have to stress the broken surround sound remote and getting up every 10 min to adjust lol

Expert

 • 

23.3K Messages

13 years ago

Aviewer thanks for posting that info.

Not finding what you're looking for?
New to AT&T Community?
New to the AT&T Community? Start by visiting the Community How-To.
New to the AT&T Community?
Visit the Community How-To.