04-06-2012 8:15 PM
im trying to hook up a 18 inch round dish with a lmn dtv 32+ to my hr 24 reciever. i've tried everything and it says problems communicating with dish. HELP!!!
04-06-2012 8:21 PM
Here are the steps to change your dish settings
From the Menu
Using the Arrow buttons navigate to - select Parental, Favorites, Setup - press Select button
Using the Arrow buttons navigate to highlight - select System Set Up - press Select button
Using the Arrow buttons navigate to highlight - select Satellite - press Select button
Using the Arrow buttons navigate to highlight - select Repeat Satellite Setup - press Select button
Follow the on screen instructions and press the - Dash button
A new screen will be shown
Use the Arrow buttons navigate to Switch - then press the Select button
In the drop-down box use the Arrow buttons to highlight 02 Multiswitch then press Select button
Use the Arrow buttons and highlight Dish Type - press the Select button
In the drop-down box use the Arrow buttons to highlight 01-18" round then press the Select button
Use the Arrow buttons to navigate to Continue until you can hight light - Watch DirectTV
04-06-2012 8:27 PM
it still isnt working. even tried my standard hd reciever. same thing. are my recievers maybe not compatible with my dish?
04-06-2012 11:16 PM
Where did you get that dish? How are you aiming it? Perhaps it's defective?
If you follow the steps in peds48's post in the EXACT order, it should work fine.
04-07-2012 5:17 AM
it still isnt working.
you don't give us much info. what is not working? Any error messages? following the above instructions to the "T" should get your receiver switch to work with your dish. of course, the dish must be aim properly in order to receive any programming.
04-07-2012 10:22 AM
it is not recognizing that a satelite is even there. the dish is hooked to the swm box at the power to swm, signal to ird is hooked into the reciever. even after setting up the reciever to the specifications above.( 01-round 18", and multi switch) still nothing. "problem communicating with dish. error code (771A)."
04-07-2012 1:13 PM
you don't need the power supply with the round dish. just connect a coax cable from this dish directly to your receiver. then follow the instructions on post # 2