how to program two remotes to run one genie server hr34

Contributor

how to program two remotes to run one genie server hr34

I bought an additional remote so that my wife & I can each have one to run the HR34 server without having to pass the one remote between us.

When I received the second remote & programmed. It worked fine but the first remote no longer worked. I then programmed the first remote & the second one did not work.

How can I get BOTH remotes to work on this server at the same time???

P.S. I'm trying to have both work in RF mode.

Message 1 of 2
Employee

Re: how to program two remotes to run one genie server hr34

Program the first remote as usual, through the receiver menu, once done press "Done"

on your second remote (assuming is RF as well)

1. Press and hold MUTE and SELECT (LED flashes twice)

2. Enter 961

3. Press CH UP

4. Enter the last 6 digits on your ID (receiver ID number) found inside the access card door

5. Press SELECT

Employee Contributor*
*I am an AT&T employee and the postings on this site are my own and don't necessarily represent AT&T's position, strategies or opinions.
Message 2 of 2
You must type a description before you click preview or reply.
Share this topic
Announcements

Need immediate assistance with your bill or technical issue? Don’t wait, Click here to chat with us. You can also check out some helpful articles below!

Additional Support