03-22-2014 4:37 PM
Did you off try doing a code search
Move the top slider to av1 press and hold mute and select wait for flashes press 991 wait for flashes press 3 then channel up
Each time you press channel up it will send out a new code if the bar Powers off its programmed.
Then press and hold mute and select wait for flashes 993
Select this will lock the volume
03-22-2014 5:27 PM
I did that until I couldn't feel my thumbs. No luck. I saw some conversations where with the right receiver/remote setup there are more possibilities. i went the menu/settings/remote route, no luck there either.
03-22-2014 5:58 PM
You have to slide remote to av1 press and hold mute and select
Wait for flashes then try these one at a time 31295 31304 31500 31868
03-22-2014 6:17 PM
just tried these. Some look familiar, when I program the number in, I am pressing the volume button downtown see if it controls the volume, the television volume appears on the screen, even though the slider is in the av1 position. What's going on with that? Is that normal?
03-22-2014 6:39 PM
You have to lock volume to av1
While in av1 press and hold mute and select flashes then 993 Select that will lock the volume
03-22-2014 7:22 PM
I have a felling that you are going around in circles for no reason. Get yourself an RC66X and use the following trick
With remote and receiver in IR mode, do the following:
1) Go to menu and set up remote like you normally would.
2) Go Select Samsung
3) Select HWD350
4) Point the remote at the Directv receiver.
5) Wait for code to load and then test the receiver
© 2017 AT&T Intellectual Property.This link will open a new window All rights reserved. AT&T, Globe logo, Mobilizing Your World and DIRECTV are registered trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks are the property of their respective owners.
Congratulations! You earned the Liz badge!