RF Remote

Tutor

RF Remote

I have a HD34-700 with two TV's connected and one universal RF remote that works fine. Can I connect another RF remote to the same receiver?

Message 1 of 7 (354 Views)
Employee

Re: RF Remote

Yes. With the first remote already programmed, do the following on the second RF remote

1. Press and hold MUTE and SELECT (LED flashes twice)

2. Enter 961 then CH UP

3. Enter the last 6 digits of the RID number found inside the access card door

Employee Contributor*
*I am an AT&T employee and the postings on this site are my own and don't necessarily represent AT&T's position, strategies or opinions.
Message 2 of 7 (20 Views)
Tutor

Re: RF Remote

I did what you said with Directv tech service. No luck. Tech then said you can only have one remote on RF for receiver. I think he just wanted to get off phone. Any other suggestions?

Message 3 of 7 (20 Views)
Employee

Re: RF Remote

Add step 4 to the above instructions

4. Press SELECT

Employee Contributor*
*I am an AT&T employee and the postings on this site are my own and don't necessarily represent AT&T's position, strategies or opinions.
Message 4 of 7 (20 Views)
Tutor

Re: RF Remote

I tried your instructions last night. Still did not work. Any other suggestions?

Message 5 of 7 (20 Views)
Employee

Re: RF Remote

What is the model of the remote control

Employee Contributor*
*I am an AT&T employee and the postings on this site are my own and don't necessarily represent AT&T's position, strategies or opinions.
Message 6 of 7 (20 Views)
Tutor

Re: RF Remote

Model is RC66RBX if my memory serves me right. I am at work but I did look at that number the other night.

Thanks,

Chester Couch

Bechtel Mechanical Group - Vessels

713-235-2322

email: ccouch@bechtel.com

Message 7 of 7 (20 Views)
Share this topic
Announcements

Need immediate assistance with your bill or technical issue? Don’t wait, Click here to chat with us. You can also check out some helpful articles below!

Additional Support