12-30-2018 5:18 AM
I am trying to find directions on how to install the wireless bridge for my Directv. I have an existing HD DVR which has two mini genies connected but not wireless (via coax whole home). DirectTV sent me the wireless genie and Wireless Bridge for self install but no directions and the tech support was absolutely no help. Hoping I can find some help here or I’m just returning them.
Any idea on how I connect this bridge to my main receiver? Will it be impossible to do with the existing Swim connector for the existing genies?
Solved by: Go to Solution.
12-30-2018 1:57 PM
Thank you for the response. I’m still unclear what is connected first. Does the coax that carries the signal from the satellite continue through the SWM first and then to the WVB and then through to the DVR?
12-30-2018 2:15 PM
You can either hook the bridge to one of the cables that was connected to the old genie minies, or you need another cable you take the cable from the main receiver hook it up to the open port on the bridge. Unscrew the cap on the 2nd port and plug main receiver to that. When it it detected the genie will prompt it on the screen. Then you go to menu whole home add client that will put the bridge into beacon mode will start to flash blue green and the wireless bridges will detect it then and give you a signal strength of excellent good fair or poor that’s when you can try to connect you enter the pin from the genie and select a location to replace follow the step till you get a picture repeat process at other location. Then hit done the wireless will freeze for a second or too and will do some updates but should work after.
12-31-2018 4:32 AM
Visit these related resourcesView DVR & Receiver Help!
|01-27-2019 5:48 PM|
|08-27-2016 1:13 PM|
|10-25-2018 8:09 AM|
|12-26-2017 11:23 AM|
|01-14-2018 3:29 PM|