Ask a question
Search in DIRECTV Forums

DIRECTV Forum

Reply
Posted Apr 19, 2014
11:16:00 AM
View profile
geniego ooh setup with cincinnati bell

I think I setup my GenieGo for OOH access, at least it passes the test from the app.

I have Cincinnati Bell Fuse Internet and a Linksys Router.  

My GenieGo uses ports 8082, 8083 according to the app clicking on the '?'.

I setup my Linsys e4200 modem for the port forwarding.

I did a tracert directv.com to see that my DSL model was a second router as 198.162.200.1.     (I found this explanation well explained in another post - thank you!)

I entered that IP in my browser and saw I had a Westell model.    I went to Directv site to set that up.  I clicked thru the westell options until I could find one that  looked like the interface I see (I couldn't find the model anywhere)

How do I configure my wireless router? | DIRECTV Support

https://support.directv.com/app/answers/detail/a_id/3875/~/how-do-i-configure-my-wireless-router%3F

Then,  I added then enabled two services 8082, then 8083.   For each one, I basically put 8082 in each field and clicked thru the next and save.    Then did 8083 the same way.     When I clicked enable, it asked about the home network, I just took how it was filled out (with my sSID).    Note sure if I really needed an IP there.    I'll find out when I try outside my network.

I think I setup my GenieGo for OOH access, at least it passes the test from the app.

I have Cincinnati Bell Fuse Internet and a Linksys Router.  

My GenieGo uses ports 8082, 8083 according to the app clicking on the '?'.

I setup my Linsys e4200 modem for the port forwarding.

I did a tracert directv.com to see that my DSL model was a second router as 198.162.200.1.     (I found this explanation well explained in another post - thank you!)

I entered that IP in my browser and saw I had a Westell model.    I went to Directv site to set that up.  I clicked thru the westell options until I could find one that  looked like the interface I see (I couldn't find the model anywhere)

How do I configure my wireless router? | DIRECTV Support

https://support.directv.com/app/answers/detail/a_id/3875/~/how-do-i-configure-my-wireless-router%3F

Then,  I added then enabled two services 8082, then 8083.   For each one, I basically put 8082 in each field and clicked thru the next and save.    Then did 8083 the same way.     When I clicked enable, it asked about the home network, I just took how it was filled out (with my sSID).    Note sure if I really needed an IP there.    I'll find out when I try outside my network.

geniego ooh setup with cincinnati bell

116 views
1 reply
(0) Me too
(0) Me too
Reply
View all replies
(1)
0
(0)
  • Rate this reply
View profile
Apr 19, 2014 1:21:48 PM
0
(0)
ACE - Expert

Are you passing this along as a tip, or is something not working?

Are you passing this along as a tip, or is something not working?

*The views and opinions expressed on this forum are purely my own. Any product claim, statistic, quote, or other representation about a product or service should be verified with the manufacturer, provider, or party.

Re: geniego ooh setup with cincinnati bell

2 of 2 (14 Views)
Advanced
You must be signed in to add attachments
Share this post
Share this post