07-21-2014 3:40 PM
I just had my service installed today, so far very satisfied. However, I'm using a JVC MX-J900 for my audio output and I can't seem to get my RC71 remote to work with it.
I already tried the Menu-->Settings-->Remote Control-->Program Remote-->Program Audio Device, but it keeps telling me "There was an issue with programming your JVC Audio with your remote. You can try again or set it up later."
I've tried the "I don't know my model option" and I was also able to find the model MXJ900 in the JVC code list, but every time I still receive the same error message that I mentioned above.
Does anyone have any suggestions?
Thanks in advance!
07-21-2014 3:56 PM
The remote needs to be on RF before it can be programmed.
To set up on RF, Press and hold MUTE and ENTER for a few seconds until you see banner on the screen. Once on RF, proceed to program as usual
07-21-2014 4:03 PM
OK, that worked! I can now control the volume using my JVC audio unit.
Should I leave the remote in RF mode?
Also, do you know how to turn ON/OFF the JVC audio unit with the RC71 remote?
07-21-2014 4:37 PM
The RC71 doesn't have the codes to turn A/V receivers on/off it was never meant to control them.
If you have line of sight to the receivers you can use IR or just leave it in RF.
07-21-2014 6:33 PM
Awesome. Thanks for the update.
Welcome to the DIRECTV DVR & Receivers boards! Check out our troubleshooting articles below and don’t forget to search the forums - your question may have been answered already!
Is your service down? Click here to chat with us!
© 2017 AT&T Intellectual Property.This link will open a new window All rights reserved. AT&T, Globe logo, Mobilizing Your World and DIRECTV are registered trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks are the property of their respective owners.
Congratulations! You earned the Liz badge!