HR 21 and SWM DISH

Contributor

HR 21 and SWM DISH


In setting up and HR21 for a SWM dish, I did  it the normal way ( that is without the 0,2,4,6,8 code). The receiver booted up normaly but at the end I found that only one  tuner had a signal.  I  went into settings and found that the proper dish had not been selected. I manually set it to the proper dish (#17 SLS3 SWM) and every thing  now seems to work fine. My question is did I lose any thing by doing it this way? An experienced reply would be appreciated.  Thanks Bob

Message 1 of 2 (258 Views)
Employee
Solution
‎08-07-2014 7:23 PM

Re: HR 21 and SWM DISH

they way you did was the way it was supposed to be done

Employee Contributor*
*I am an AT&T employee and the postings on this site are my own and don't necessarily represent AT&T's position, strategies or opinions.
Message 2 of 2 (36 Views)
Share this topic
Announcements

Welcome to the DIRECTV DVR & Receivers boards! Check out our troubleshooting articles below and don’t forget to search the forums - your question may have been answered already!

Is your service down? Click here to chat with us!

Additional Support