01-17-2017 12:59 PM
I am attempting to route my NVG510 to a phone module, As long as as hook up one output in the module it works okay, As soon as I hook up the second module the router fails. I have checked the wiring to verify everything is wired correctly.. Any suggestions?
01-17-2017 1:53 PM
I am attempting to route my NVG510 to a phone module, As long as as hook up one output in the module it works okay, As soon as I hook up the second module the router fails....
01-17-2017 2:52 PM
I do not have enough output ports. So I am attemptting to route one output from the modem to a phone module with eight more output ports. This will allow me to hardwire the devices I am using to stream TV. After I run the output from the modem and connect more than one output from the phone module the modem does not send a signal. It operates okay as long as I hook up one device only out of the phone module
01-17-2017 5:24 PM
Your description is that of a switch....
Do you have a switch? Such as Netgear GS108 or similar?
Using standard straight thru patch cables not cross over cable?
Next question, the 510 is an ADSL2+ gateway, what is the speed your subscribed to?
ADSL2+ could be as slow as .75, 1.5, 3, 6, 12, or on high end 18.
Example if have 1.5M internet.... Netflix in SD needs 1.5M, no other device would have any bandwidth to function.
If have 3M internet, (1) Netflix in SD would consume 50% of bandwidth.
If have 6M internet, (1) Netflix in HD would consume 5.5 (90%) of bandwidth.
01-18-2017 6:41 AM - edited 01-18-2017 6:43 AM
@MSECPDEP1, as my thoughts indicated, the correct device for connecting multiple Ethernet connections together is a Switch (or a hub, though hubs are pretty much obsolete these days). You cannot treat cabling used for twisted pair Ethernet the same way you would cabling for analog telephones; that will not work at all. Twisted-Pair Ethernet cabling uses point-to-point or star topology, not a bus like 10base5 or 10base2, which use Coax as a shared medium and carrier sense multiple access with collision detection (CSMA/CD) to prevent nodes talking over each other. Only two nodes are ever on a Twisted-Pair Ethernet cable; one on each end.
Look for Gigabit Ethernet Switch on Amazon or wherever you like to buy electronics. The Netgear GS105 or GS108 are often used by AT&T when needed for this application.
I thought that you might have been attempting to connect multiple phones to the VOIP jack on the NVG510. That is possible.
Welcome to the internet boards! Check out our troubleshooting articles below and don’t forget to search the forums - your question may have been answered already!
Service acting up? Click here to troubleshoot now!
For DSL related issues. We highly recommend chatting with our teams to address this as quickly as possible.