01-24-2011 11:58 AM
Just had my 2Wire gateway box replaced after the last one stopped working, and now my HP printer wont work. Documents fail to print, saying "The spooler was unable to connect to your printer. This can be caused by your printer being turned off, the cable being unplugged, or being connected to a VPN, which will block your access to the local network." The printer is connected via ethernet cable to the gateway, and there is a home network. It's an HP 7410 All-in-one. Please advise how to get my printer back working again.
Solved! Go to Solution.
01-25-2011 10:18 AM - edited 01-25-2011 10:20 AM
Reset your printer it is probably looking for your old RG . Check in your printer settings if preferred DNS setting
01-31-2011 2:40 PM
I printed out a Network Configuration Page from the printer and compared the IP address to the one listed under printer port settings. I needed to configure the port with IP address 192.168.1.64. The last couple numbers were off which was the problem. Printer works great again. Thanks!
Welcome to the internet boards! Check out our troubleshooting articles below and don’t forget to search the forums - your question may have been answered already!
Service acting up? Click here to troubleshoot now!
© 2016 AT&T Intellectual Property.This link will open a new window All rights reserved. AT&T, Globe logo, Mobilizing Your World and DIRECTV are registered trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks are the property of their respective owners.
Congratulations! You earned the Liz badge!