Explore & discover

Helpful Links

How to Access Pace 5268AC after enabling DMZ+ mode?

Announcements...
Are you having trouble logging in? Is your email password not working? Let us show you how to Reset your Email Password using myAT&T!
Contributor

How to Access Pace 5268AC after enabling DMZ+ mode?

I have a Pace 5268AC connected to a Ubiquity EdgeRouterX. I successfully enabled DMZ+ mode on the 5268AC and have internet, etc. Now I want to get back into the 5268AC 's admin page to adjust settings, but the IP 192.168.1.254 doesn't work and I don't see it in the DHCP table (which I guess makes sense since it is sitting upstream of the EdgeRouter. So how do I connect to it? Do I have to grab a laptop and plug directly in?

1,260 Views
Message 1 of 4
Employee
Solution
Accepted by topic author
Accepted by RedPulse
‎12-08-2017 11:48 AM

Re: How to Access Pace 5268AC after enabling DMZ+ mode?

Either hardwired Ethernet or connect to the gateway wireless SSID/password if you did not turn off the WiFi on gateway.

*I am an AT&T employee, and the postings on this site are my own and don't necessarily represent AT&T's position, strategies or opinions.
Tags (1)
Message 2 of 4
Contributor

Re: How to Access Pace 5268AC after enabling DMZ+ mode?

Thanks, that did it. Turns out my EdgeRouterX (or DMZ+ mode in general) was severely limiting the bandwidth (topping out at 400mbps) vs plugging my switch directly into the Pace RG. The EdgeRouterX is supposed to be gigabit so not sure why that would be limiting the bandwidth though...

Message 3 of 4
Contributor

Re: How to Access Pace 5268AC after enabling DMZ+ mode?

 Redpulse,

 

Just got an EdgeRouter X myself. Could you share the specifics of your working config? Not a network engineer per se. Looking to leverage my static ip addresses for home use.

 

Thanks mate.

 

Kevin

Message 4 of 4
Share this topic
Share this topic
Additional Support