02-01-2013 2:43 PM
My setup is as follows: Coax comes from outside my house (presumably from the NID). That coax is attached to a diplexer (VDSL port). Coax goes out from the diplexer (Combined port) to my Residential Gateway. All receivers are connected to the RG via Cat5e, I'm not using coax HomePNA at all.
My question is, since I'm only using coax to get from the NID to the RG, do I need a diplexer or is there any benefit to using one? Should I just use a simple connector instead?
I've been running into some TV stuttering issues recently with uncorrected blocks and starting to ask questions.
Solved! Go to Solution.
02-01-2013 3:23 PM
02-03-2013 5:27 PM
Make sure if you use a barrel, its rated for 3Ghz as a lower quality barrel will actually cause more issues than the diplexer. These can usually be identified by a blue center. As for why there is a diplexer in the network without any of the boxes running on coax, it could be that the tech installed it as a grounding source or reused an exisitng one that was previously installed to feed the signal to that room. The HPNA side should have at least been capped off though with a 75 ohm terminator.
I am an AT&T employee and the postings on this site are my own and don’t necessarily represent AT&T’s positions, strategies or opinions.
Welcome to the internet boards! Check out our troubleshooting articles below and don’t forget to search the forums - your question may have been answered already!
Service acting up? Click here to troubleshoot now!
© 2017 AT&T Intellectual Property.This link will open a new window All rights reserved. AT&T, Globe logo, Mobilizing Your World and DIRECTV are registered trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks are the property of their respective owners.
Congratulations! You earned the Liz badge!