Community Support
•
2.7K Messages
Connecting your Printer to WiFi
Connecting your Printer to WiFi
Connecting via WPS
- Locate your printer manual. You will want to learn how to access the printer WiFi settings. Some printers are able to connect via WPS. If your printer has the capability to connect this way:
- Log into your gateway at http://192.168.1.254.
- Go to the Wireless Settings
- Enable WPS and Save
- After WPS is enabled, press the WPS button located on the front of your gateway.
- Then press the WPS button on the printer. The printer should automatically connect in less than a minute.
Connecting via WiFi Password
- If your printer connects via a Wireless password, you will want to find your printer manual to find out how to enter it. Most printers come with a setup disc to guide you through the process. You can find your Network Name and Wireless information here.
David, AT&T Community Specialist
AT&T Help
Need help with an account specific question? Post a new question here on the forums by clicking the "Ask a Question" button.
For additional support, please visit us at our AT&T services hub.
*I am an AT&T employee, and the postings on this site are my own and don't necessarily represent AT&T's position, strategies or opinions.
Accepted Solution
Official Solution
ATTHelpForums
Community Support
•
2.7K Messages
6 years ago
Need help connecting other devices. Find out more information here.
David, AT&T Community Specialist
1
0
kurtlanddavies
New Member
•
2 Messages
3 years ago
Thank you so much. Very helpful to this old gal. worked like a charm.
Question though, how did going to that web address connect with my particular AT and T router?
0
0
JefferMC
ACE - Expert
•
35K Messages
3 years ago
192.168.1.254 is a local, "non-routable" address, see this article in Wikipedia about private IP addressing. All AT&T Routers come out of the box with this as their LAN-side address, though you can change it (mine is actually 192.168.2.254).
0
jackdaunting
New Member
•
1 Message
3 years ago
Connect Brother HL2270DW to ATT ARRIS BGw210
Go to gateway above. Go to WIFI tab
Look on side of Router and get Device ID put that in on pop up screen
Go to WPS button and hit the button
You will see WPS on router front blinking
Putt slim object into printer hole "A" below the printer cable input port. Hold slim object in hole for 3 secs. Toner light on top will blink
Printer will print a sheet with WIFI protected setup PIN CODE
Put Pin code into WPS PIN box
Wait a couple of minutes and the Printer will go to ready and print out a sheet that says Connection: OK
0
0