11-18-2013 3:08 PM
I was just notified that U-verse is now available to my home. Before we were "too far away" from the node or whatever although I am unaware of anything different in the neighborhood.
I am interested in U-verse for all three service but have a concern about the suitability of the existing phone and cable coax wires now in the house. They have been there for 41 years and the drop goes to a ATT "box" in the back yard that I know floods half way up it every few years. It has been "replaced" three times. The Comcast cable coax splits 4 ways in an upstairs closet. My current cable, phone and DSL service seems OK but I don't want to commit to a change until I can feel more assured that the existing infrastructure won't degrade things a great deal or prevent needed connectivity. Should I be concerned?
Solved! Go to Solution.
11-18-2013 5:06 PM
With a U-Verse install, if the installer needs to replace the current wires and run new ones, the first 3 cables are free. U-Verse runs best on CAT5e cable, so in most circumstances, the installer will pull new CAT5 wiring to the RG (modem) and to at least one set top box (DVR). If you're only putting in 3 TV's, the most likely course that the installer will take is to put wireless boxes in the other two locations. If new wiring needs to be pulled, it could take a few hours, but in the end, I believe you'll have a much better experience with TV. I know I wouldn't trade my existing services (U-Verse - all three products) for anything.
11-18-2013 6:14 PM
11-18-2013 11:58 PM
11-19-2013 3:56 AM
Much appreciated. A great answer... you addressed each of my questions/concerns in a very clear way. Two additional questions... Are the WAP and the RG two seperate devices normally connected by CAT5? And why your suggestion that the lower use TV be the one nearest the RG on an Ethernet cable (perhaps because it wouldn't count as a wire run but Ethernet is not as good as CAT5?)
11-19-2013 4:27 AM - edited 11-19-2013 9:30 AM
calliedo - Hopefully MT is getting some sleep after putting together that great answer at 3am, So, I would jump in on these two easy ones.
Yes, the WAP and RG are two separate devices connected by cat5. The RG is combo modem/router for internet & TV. WI-fi is internet only. WAP is only wi-fi for STB/TV.
The lower use TV is used for the DVR because most only support three HD & you need to watch the fourth HD on another STB, A new rollout supporting the fourth HD makes this moot.
It should be connected cat5 because it is the conduit through the RG for whole house DVR. COAX may work well, but why take a chance, If it is near the RG it is just a short patch cord. The leg between the RG & DVR carries more data than any other leg & in both directions.
Welcome to the internet boards! Check out our troubleshooting articles below and don’t forget to search the forums - your question may have been answered already!
Service acting up? Click here to troubleshoot now!
© 2017 AT&T Intellectual Property.This link will open a new window All rights reserved. AT&T, Globe logo, Mobilizing Your World and DIRECTV are registered trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks are the property of their respective owners.
Congratulations! You earned the Liz badge!