07-13-2014 6:06 AM
I have an AT&T Uverse 2WIRE225 3801HGV gateway that operates on the 802.11g wireless protocol. I have two devices cabled into the LAN ports on the gateway: a network-attached storage (NAS) device and a Sonos Bridge. All other devices in the house (e.g., Mac computers, iOS devices) connect wirelessly to the gateway.
I want to move to an 802.11n wireless network. I have a spare Apple Airport Exteme (AE) that I can use for this. From reading articles on the web, I think there are two general ways to do this.
OPTION 1 - Set Up AE As My Only Router
Continue to use the 2WIRE225 gateway as the modem, but turn off its ability to be a router. Run an ethernet cable from a LAN port on the gateway into the WAN port on the AE. Now the AE will be the only working router in the house. (I know I have to make configuration changes on the gateway and on the AE, but I won't go into that here.)
OPTION 2: Use 2WIRE225 As My Cabled Router, Use AE As My Wirelss Router
Continue to use the 2WIRE225 gateway as the modem, and disable only its wireless capability. As above, run an ethernet cable from a LAN port on the gateway into the WAN port on the AE. Now, the 2WIRE225 is still acting as the router for devices that are cabled into the gateway LAN ports, but the AE is acting as the router for all devices that connect wirelessly.
Is my above understanding correct? What are the advantages of going with Option 1 versus Option 2? Thx
Solved! Go to Solution.
07-13-2014 6:41 AM
Option 2 you can see everything on your LAN including your STB's and it will give you the least amount of trouble if you are talking Bridge Mode on the Airport.
Option 1 will put you behing the RG isolating you from it sort of since you can't truly put the RG in a DMZ.
07-13-2014 10:32 AM
07-13-2014 10:07 PM
Unless you have specific need to use the AE in any other mode than bridge then the answer is no.
I have been running my Time Capsule in bridge mode for a year now its trouble free and the wireless is turned off in the RG.
07-24-2014 3:55 PM
I turned wiress off on the RG as suggested. Airport Extreme has been working for a week now in bridge mode without problem. Thanks!
09-14-2014 6:13 PM
I have a similar situation, but I would also like to connect another computer to the Airport Extreme via Ethernet. Should it be configured as DHCP, or should it bridge the Airport Extreme to make use of the dynamic addresses that the 2wire is already providing? (I couldn't get either to work.)
01-09-2015 8:44 AM
I appreciate the above information, does this mean I can't use my AE to extend the range of my WiFi network?
09-22-2016 11:35 AM - edited 09-22-2016 6:10 PM
Welcome to the internet boards! Check out our troubleshooting articles below and don’t forget to search the forums - your question may have been answered already!
Service acting up? Click here to troubleshoot now!
© 2017 AT&T Intellectual Property.This link will open a new window All rights reserved. AT&T, Globe logo, Mobilizing Your World and DIRECTV are registered trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks are the property of their respective owners.
Congratulations! You earned the Liz badge!