08-21-2011 6:24 AM
I need to set up port forwarding and found a very good explanation from this forum of how to go about doing that. However, when I got to the point where I had to put in my password, it wasn't accepted. I understand the password is on the label of the 2wire. Is this the network key that they're referring to? I've tried that, and I get login failed. Can anyone help here?
Solved! Go to Solution.
10-10-2012 3:37 PM - edited 10-10-2012 3:39 PM
My new 3801HGV doesn't have a device access code on the label, only the wireless SSID and password, and a link to AT&T support.
When I set DMZ Plus for my internal router, it accepted it without the password, but when I went to disable the 2wire wireless, it asked me to either set the factory password or my own, and when I set my own, it ignored my setting. It later gave a hint that it wanted the factory password and not the one I set.
10-11-2012 1:12 AM
Disregard this, I only noticed the obvious removable yellow sticker, not the dark gray on black semi-permanent label on the other side of the unit.
Welcome to the internet boards! Check out our troubleshooting articles below and don’t forget to search the forums - your question may have been answered already!
Service acting up? Click here to troubleshoot now!
© 2017 AT&T Intellectual Property.This link will open a new window All rights reserved. AT&T, Globe logo, Mobilizing Your World and DIRECTV are registered trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks are the property of their respective owners.
Congratulations! You earned the Liz badge!