Skip to main content
AT&T Community Forums

Tutor

 • 

5 Messages

Mon, Sep 2, 2019 4:21 PM

Connecting a new tv to existing U-verse dvr

First timer.  Old tv dead and gone.  What is power up sequence of tv, ext audio, and U-verse DVR.  Is it HDMI connect to tv & dvr, audio connect to dvr, plug in tv, plug in dvr, power on tv, power on dvr?   the ext audio is to send audio to hearing aids, connecting both with optical on tv and dvr.  Thanks 

Responses

Accepted Solution

Official Solution

_xyzzy_

Expert

 • 

15K Messages

a year ago

Gateway is ethernet connected to dvr's network port.   DVR hdmi connected to tv (usually).   Any additional audio devices connect to the tv but I think the optical out on the dvr might also work.  Maybe even the audio out RCA jacks as well.  Less sure about those though.

 

Boot gateway first (plug it in) and always leave it on.  Next dvr.  Tv doesn't matter since it just shows what the dvr is feeding it (make sure the tv's input is selecting the hdmi port you are using on it).  The reset is up to you.  That stuff can be on or off at any time.  It obviously isn't going to receive any signal until dvr and/or tv are ready.

 

Note in order for the att remote to control on/off and volume of both the dvr and the tv (and maybe another audio device) you need to program it. Read the att remote's user manual on how to do that.

Tutor

 • 

5 Messages

a year ago

Thank you for your help. Got 2 TV's set up easily with your instructions.

Get started...

Ask a new question