Skip to main content
AT&T Community Forums

Contributor

 • 

3 Messages

Sat, Sep 30, 2017 2:26 PM

hooking up an emitter to uverse dvr

Where should the emitter be hooked up to the Uverse DVR

Responses

Accepted Solution

Official Solution

ATTHelpForums

Community Support

 • 

2.4K Messages

3 years ago

Hi @k.lohman10,

 

I believe you are talking about an IR Emitter. If that is the case, on most receivers, it is to the right of the red record light. To test, you can put a piece of tape or something to block that area and see if your remote works. If it does not, that's where the IR sensor is. Hope this helps.

 

David, AT&T Community Specialist

AT&T Help

Need help with an account specific question?  Post a new question here on the forums by clicking the "Ask a Question" button.
For additional support, please visit us at our AT&T services hub.

*I am an AT&T employee, and the postings on this site are my own and don't necessarily represent AT&T's position, strategies or opinions.

Accepted Solution

Official Solution

JefferMC

ACE - Expert

 • 

17.3K Messages

3 years ago

A single thickness of tape will often not block IR signals into the IR receiver of the set top.  In some cases, it actually only dampens it enough to improve accuracy of reception from a "too hot" remote control IR emitter

Award for Community Excellence 2019 Achiever*
*I am not an AT&T employee, and the views and opinions expressed on this forum are purely my own. Any product claim, statistic, quote, or other representation about a product or service should be verified with the manufacturer, provider, or party.

Get started...

Ask a new question