atomarchio's profile

New Member

 • 

4 Messages

Saturday, August 27th, 2022 5:40 PM

TL86103

I just purchased TL86103 and am only using with an iphone via bluetooth.

Is there a way to remove L1) no line and L2) no line from appearing?

When I press speaker it defaults to line 1 and I would like it to default to bluetooth or Cell a.

Please help.  Thanks.

Accepted Solution

spoom2

ACE - Master

 • 

17.5K Messages

5 months ago

Did you finish entering the code? Since it's a code you probably won't see it displayed. Just do as the directions say and see if you get the confirmation tone. It is possible you just push the buttons it tells you to. 

(edited)

spoom2

ACE - Master

 • 

17.5K Messages

5 months ago

Manual found here the only way I know of to keep it from showing no line is to supply 48vdc on the tip and ring. As far as the speaker automatically choosing the cell you'll just have to read through the manual, I kind of doubt it.  

New Member

 • 

4 Messages

5 months ago

No big deal, i've kinda figured it out.  The previous brand phone I owned had a way to turn off Line 1 and/or 2.  However, that's probably not necessary with TL86103.  Thanks.

spoom2

ACE - Master

 • 

17.5K Messages

5 months ago

Page 51 of the manual PDF page 57 tells you how to turn on and off no line message

New Member

 • 

4 Messages

5 months ago

How do you get either the base or cordless into idle mode?  For some reason I can't figure out after reading those pages a few times.

Please help.  Thanks.

spoom2

ACE - Master

 • 

17.5K Messages

5 months ago

Just means not using them. Pick it up and push menu without pushing anything else. From the base just leave it hung up.

(edited)

New Member

 • 

4 Messages

5 months ago

That doesn’t work when you push menu you then can’t type a number as the instructions state. It’s not possible

Not finding what you're looking for?
New to AT&T Community?
New to the AT&T Community? Start by visiting the Community How-To.
New to the AT&T Community?
Visit the Community How-To.