Skip to main content
AT&T Community Forums

Contributor

 • 

2 Messages

Thu, Aug 4, 2016 4:37 PM

How do I change DirecTV video bridge from wired to wireless connection to ??44 receiver?

Hi,

My video bridge was connected to the receiver wirelessly but about a year ago a tech ran a coax from it to the receiver.  Now due to the addition of a room the coax will be disconnected for a month or two and I need to go back to wireless. What are the instructions for doing so?  A link will be fine.

 

Thanks

Responses

Accepted Solution

Official Solution

peds48

Expert

 • 

36.2K Messages

4 years ago

The Wireless Video Bridge MUST connect to the SWM network via coax cable.  It can't run wireless to the DIRECTV system. The Wireless Video Bridge ONLY connects wirelessly to the wirekess clients.

mdram4x4

ACE - Master

 • 

9K Messages

4 years ago

to which receiver? a mini?

if its a wired mini, you would need to get a wireless mini


----------------------------------------------------------------------------------------------------------------------
Anything below the is a signature :
Note: This is a customer to customer forum, I am just a customer. Employees are identified as such.
Award for Community Excellence 2019 Achiever*
*I am not an AT&T employee, and the views and opinions expressed on this forum are purely my own. Any product claim, statistic, quote, or other representation about a product or service should be verified with the manufacturer, provider, or party.

Get started...

Ask a new question