Available Now: Buy the new iPhone 14, iPhone 14 Pro and iPhone 14 Pro Max from AT&T!
Need help with your equipment?
w_h's profile

Tutor

 • 

3 Messages

Tue, Apr 10, 2012 1:57 PM

Upgraded to U-verse Max and only get 2.0 Mbps download if im lucky.

Yesterday I switched from Elite dsl to U-verse max (12 Mbps).  Ran a speed test and only hit a max of 2 mbps if im lucky, and average around 1.6 with my wired pc.  Uploading only .25 mbps and doesnt really change.  Ran a ping test and had 0% packet lose, 0 ms jitter and a ping of 26 which is great.  I only have the U-verse internet.  Nothing else is connected or running.

Im using the Motorola NVG510 At&t sent.  Not sure what is going on here.  Ive searched high and low for any info, but most people with slow u-verse max were still getting a much faster download speed than just 2 mbps.  Any ideas?

Accepted Solution

Official Solution

Tutor

 • 

3 Messages

10 y مضت

Wow, changed my filter configuration and am now downloading around 10 mbps, and getting almost 1 up.

Shyster951

Scholar

 • 

222 Messages

10 y مضت

Well, there's always the reboot the modem and see if that fixes it approach.

If that doesn't work, I'd suggest a call to Tech Support as even though the download speeds are 'maximum's' and not guaranteed, and speeds may well vary from test to test - a little, you're getting no where near the speed I think you should be getting.
JefferMC

ACE - Expert

 • 

29.9K Messages

10 y مضت

There is a diagnostic page on the NVG that will show your line rate both up and down.  Since I don't have that modem, I'm not real familiar with how to get to it.  Start at http://192.168.1.254 and wander around until you find it.

 

Anyway, that information will tell you whether your speed issue is due to your line conditions or something else entirely.

 

Tutor

 • 

3 Messages

10 y مضت

Broadband Status

 

Downstream Sync Rate (kbps)1787
Upstream Sync Rate (kbps)288

 

Downstream and Upstream Statistics
 DownstreamUpstream
SN Margin (dB)6.09.2
Line Attenuation (dB)71.044.2
Output Power(dBm)18.510.8
Errored Seconds1627139
Loss of Signal00
Loss of Frame00
FEC Errors00
CRC Errors4465160

Contributor

 • 

2 Messages

10 y مضت

I'm afraid your connection won't be very consistent. Your Noise Margin and Line Attenuation are not adequate enough for 12 Mbps. If you get intermittent connection... Contact support as you might have a bridge tap or something wrong with your line.
JefferMC

ACE - Expert

 • 

29.9K Messages

10 y مضت

Cool. Glad you found the problem with the way the filters were installed. If you have a chance, post the stats the way they are now.

Contributor

 • 

2 Messages

9 y مضت

What exactly was the "change" to your filters that you performed?  I just upgraded to Max, and things actually feel slower, though I haven't done any speed tests.  Thanks

Tutor

 • 

7 Messages

9 y مضت

Same problem.....what "filter" change(s) did you make???

 

Need help?
New to AT&T Community?
New to the AT&T Community? Start by visiting the Community How-To.
New to the AT&T Community?
Visit the Community How-To.