Available Now: Buy the new iPhone 14, iPhone 14 Pro and iPhone 14 Pro Max from AT&T!
ems4him's profile

Contributor

 • 

1 Message

Wed, May 13, 2015 5:12 AM

iPhone app - custom route traffic using sonicwall to ATT UVERSE GW

I've been reading several posts about how its possible to configure the UVERSE apps to send multicast traffic through a 3rd party router to the GW of the UVerse box.

 

My setup is this:

 

1)  Aruba AP > Managed Switch > Sonicwall Router > ISP

 

2)  Uverse Network for TVs only (WiFi turned off... its logically and physically independent of above configuration)  

 

They are on separate subnets as well.  (172.16.0.0/24 & 192.168.100.0/24)

 

I have separate ISP and the uverse TVs are not connected to the same switch.

 

I've connected a cable from my sonic wall to the Uverse switch (on the RG itself) to essentially "bridge" the connection...

 

I am trying to make the apps recognize the connected ATT Gateway 

 

I know that Uverse uses SSDP protocol on 239.255..... but am a little iffy on the sonicwall configuration itself.

 

I have tried making a handful of access rules, address objects etc... and would love your help!

 

Thanks,

 

Eric

JefferMC

ACE - Expert

 • 

29.9K Messages

7 y مضت

Per AT&T's published requirements, AT&T U-verse High Speed Internet is a requirement to use the U-verse apps to control IPTV Receivers.  I believe this requirement is actually enforced.

 

So, the fact that you say you have another HSI provider would appear to spell doom for your plan.

Need help?
New to AT&T Community?
New to the AT&T Community? Start by visiting the Community How-To.
New to the AT&T Community?
Visit the Community How-To.