Contributor
•
2 Messages
Export 2 wire settings?
Good morning, I’ve searched the forum and don’t see an answer that addresses my question I have the Uverse 2-wire router and I’m having the same issue it looks like many others here have with dropped signal and continual short outages. I’ve talked to AT&T several time and they want me to do a factory reset know. I hesitate to do this because I had to do a lot of custom setup to get my network working.
My question is *can I export all the setting to a file* so I can you the data to recreate the setting after the reset? If not which screens should I screenshot to make sure I cover all the user related settings?
Thanks in advance for any help!
Accepted Solution
Official Solution
SomeJoe7777
Expert
•
9.4K Messages
12 years ago
Most config parameters are on the following pages:
- http://192.168.1.254/xslt?PAGE=C_1_1
This is where the additional network is defined if you have static IPs.
- http://192.168.1.254/xslt?PAGE=C_2_1
Your wireless network settings.
- http://192.168.1.254/xslt?PAGE=C_2_4
IP Address allocation page, normally not used unless you have static IPs.
- http://192.168.1.254/xslt?PAGE=C_3_1
Firewall configuration page, you'll need to select your different computers and note what firewall options are selected for each one.
- http://192.168.1.254/xslt?PAGE=C_3_2
Firewall advanced configuration, you may have some settings changed here if you're using DMZPlus mode.
0
Accepted Solution
Official Solution
SomeJoe7777
Expert
•
9.4K Messages
12 years ago
0
Tom Sala
Contributor
•
2 Messages
12 years ago
Thanks for the prompt reply!
1 other question, I recall setiing a router behind a router in the configuration however I don't see that setting now on any of the screens I've been to. Is that setting in the router or not?
Thanks again.
0
0