Check out AT&T's Valentine's Day Gift Guide for ideas & deals on the new Samsung Galaxy S23!
B

New Member

 • 

2 Messages

Monday, December 14th, 2020 7:20 PM

Bridge mode for 2Wire5268AC

Need help putting my unit into bridge mode so I can best use TP link Deco Mesh network.  Also have Wireless Access Point unit attached to the 2wire unit that the ATT tech attached when he added another tv to our system. 

I have no laptops that can connect directly to the router via network cable.  

Unsure what to do.  Need specific instructions please.

Accepted Solution

Official Solution

browndk26

ACE - Professor

 • 

4.9K Messages

2 years ago

No true bridge mode. 

dmz plus for the pace gateway

https://www.att.com/support/smallbusiness/article/smb-internet/KM1188700/

 Bottom of the article. 

Check tp link for instructions as well. You may be better off with the tp link in access mode. 

leave the WAP connected to the gateway. 

(edited)

Not finding what you're looking for?
New to AT&T Community?
New to the AT&T Community? Start by visiting the Community How-To.
New to the AT&T Community?
Visit the Community How-To.