New Member
•
2 Messages
Connect NetGear NightHawk X4S to ATT/Arris BGW210 on ATT Fiber Internet
I am looking for the set-up instructions. I know I need to enable bypass mode and then turn off wireless on the Arris BGW210 to avoid interference. I am looking for step by step instructions before I waste hours trying to configure this myself. Thank you in advance!
Accepted Solution
Official Solution
dave006
Scholar
•
3.7K Messages
1 year ago
The AT&T Gateways don't support bypass mode. They have a feature know as IP/Passthrough model for your NetGear NightHawlk XS4
Forum Link:
Please follow these instructions to setup IP/Passthrough mode:
https://forums.att.com/conversations/att-internet-equipment/bridgemode-vs-ip-passthrough-setup-information/5defbfffbad5f2f606ad5ed2?page=12
Alternate instructions of the same setup:
https://www.att.com/support/smallbusiness/article/smb-internet/KM1188700
Review the material and please post bask to this thread for any questions before you make the switch. You can't really break anything. You can always reset the routers and start again.
Dave
0
0
ATTHelp
Community Support
•
215.1K Messages
1 year ago
Let's get your third party device connected, @jmartatx001!
You can view our article that covers configuring IP Passthrough on your BGW210. Refer to the section titled configuring IP Passthrough for the information that you are requesting.
Let us know if you need help after viewing the article!
CalebP, AT&T Community Specialist
0
0
jmartatx001
New Member
•
2 Messages
1 year ago
Hi, are there any settings on the Netgear NighthawK X4S I need to change?
0
0
tonydi
ACE - Guru
•
9.9K Messages
1 year ago
Disable QoS and Traffic Manager if enabled.
0
0